


I bought a new camera (the Fujifilm XT20) last year. Since then, it’s been with me on lots of holidays, days out and blogging events… but every single time I use it, I wish it had a more exciting neck strap! I’m just not keen on the plain black one it came with.
However, last week I was wandering around Hobbycraft (story of my life) and I came across the coolest fabric ribbon. It had a mathematically accurate tape measure printed across it! As soon as I saw it, I knew it was finally time for me to update that boring camera strap and make my own.
Of course, you can use any fabric ribbon you want to recreate this DIY camera strap. In fact, it’s so quick and easy, you could make several. How about coordinating camera straps for your outfits? Too much? Okay. Let’s get on with the tutorial… 🙂

Tape measure DIY camera strap
There are three main parts of this DIY camera strap. A fabric ribbon (for strength), a decorative ribbon (to make it look cool) and a leather strip (to feel comfortable on your neck). They’re all joined together with fusible interfacing, so it’s completely no-sew.
Supplies and tools
- Black fabric ribbon, minimum 1.5cm wide
- Tape measure ribbon, minimum 1.5cm wide
- Fusible interfacing
- 15cm strip of soft leather
- Adjusters (you can reuse the ones on the strap that comes with the camera)
- Iron and ironing board
- Fabric scissors
Tutorial
1. Drape one of your ribbons around your neck and determine how long you would like it to be. Make sure it will allow the camera to hang in a comfortable position. Once you’re happy, measure how long your ribbon needs to be. To give a rough idea, mine was 85cm.
2. Cut your tape measure ribbon to the length you’ve determined.
3. Cut your black fabric ribbon 20cm longer than the tape measure ribbon (to allow extra for the adjustable section of the strap).
4. Similarly, cut your fusible interfacing to the original length (same as the tape measure ribbon). However, it’s likely that your fusible interfacing will be wider than your ribbon – so you may need to cut that along its length too, so it’s a little narrower. For instance, my ribbon was 1.5cm wide, but my interfacing was 2cm wide, so I cut off 0.5cm all along the side of the interfacing.
5. Lay one end of your black fabric ribbon flat onto your ironing board. Approximately 10cm from the edge, place the fusible interfacing and tape measure ribbon on top of it, in that order (so the interfacing is sandwiched in the middle). This will leave you with 10cm of uncovered black ribbon.


6. Using the settings recommended for your fusible interfacing, iron the three layers together to permanently adhere them. Work your way along the full length of ribbons, until you get to the other end. You should be left with approximately 10cm of uncovered black fabric at this end, too.
7. Cut a 15cm strip of soft leather (the width should be the same as your ribbon). Cut an identical sized piece of fusible interfacing. Place the leather suede-side down onto your ironing board, then place the fusible interfacing on top.
8. Locate the centre of your glued together ribbons. Place the centre of the ribbons on top of your leather strip and interfacing, so the black fabric ribbon is face down (and the tape measure ribbon is face up). Using your iron as earlier, fuse together the layers.
9. Finally, thread the ends of your strap (that were not fused with the tape measure ribbon) through your strap adjusters. My strap adjusters were narrower than my ribbon, so I simply folded the ribbon in half to fit. Attach this to your camera and adjust to fit.

I am MUCH happier with my DIY camera strap. It’s such an improvement over the boring black one I used to have!
I love the hint towards my love of sewing – and if I ever want to measure things, it’ll be pretty handy! 😛 – Mike.
Don’t forget to Pin this image, so you can make it later!


No Comments